Community R2SUBDF Bedienungsanleitung Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 6
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
AUDIO VISUAL SYSTEMS 27 4116-
4
© BNA Consulting, Inc.
1. Where required for compliance with NEC 406-8 (receptacles installed outdoors
for use other than with portable tools or equipment), provide weather-tight device
covers that provide complete protection with the cord and cap inserted into the
wiring device. Provide units that mount on either single or double gang devices.
2. Provide products of one of the following manufacturers:
a. Intermatic WP1020 or WP1030
b. P&S WIUC10C or WIUC20c
B. FOOTBALL FIELD:
C.
SYM. DESCRIPTION QTY. MODEL NO.
CABLE, SPEAKER 12 AWG A/R WEST PENN 227
BELDEN 8477
S-52
LOUDSPEAKER, LONG-THROW
50 DEGREE X 20 DEGREE
3 COMMUNITY R2-52Z
S-SW
LOUDSPEAKER, SUBWOOFER
GROUND MOUNT
1 COMMUNITY R2SUBDF
DIGITAL SIGNAL PROCESSOR
12 INPUTS X 8 OUTPUTS
CONTROLLER
1 BSS BLU-100
BLU-8
POWER AMPLIFIER
4 CHANNELS X 1250 WATTS
1 CROWN DCi 4|1250
TABLE CUBBY OPTION 1
(2) XLR 3-PIN
(2) RJ-45
(1) ACTIVE AUDIO W/2 INPUTS
(1) AAP BRACKET KIT
1
EXTRON CABLE CUBBY 500
70-103-14
70-491-12
70-110-13
70-1039-01
TABLE CUBBY OPTION 2
(2) XLR 3-PIN
(2) RJ-45
(1) ACTIVE AUDIO W/2 INPUTS
1
EXTRON HSA 400
70-110-13
70-103-14
2.3 CABLING
A. Cable as specified is manufactured by Gepco wire equals of West Penn, and Belden are
acceptable. Cables are to be labeled within 6” from both ends with the source and
destination clearly legible.
B. Cables shall be grouped according to their signal type, grouped cables shall be Velcroed
together, and NO zip ties shall be used.
C. Cables shall not receive excessive force when being installed.
D. Cables that have been damaged during installation shall be replaced at contractors
expense. Contractor shall verify that all connections are in proper working order,
terminated correctly and provide documentation to engineer prior to final walk through.
E. Cables listed below may or may not be plenum rated, it shall be the responsibility of the
contractor to determine if plenum rated cable is required. The AHJ shall have the final
say if plenum cable is required, and replacement of cabling shall be at no cost to the
owner.
F. Loudspeaker: Gepco SSUB122
1. 12/2 bare copper, premium grade S-R PVC.
PART 3 EXECUTION
3.1 INSTALLATION OF AUDIO/VISUAL SYSTEMS:
A. Install Audio-Visual systems and ancillary equipment as indicated on drawings and in
accordance with equipment manufacturer’s written instructions, and the NEC, and with
Seitenansicht 3
1 2 3 4 5 6

Kommentare zu diesen Handbüchern

Keine Kommentare