Community S-series Installationshandbuch PDF herunterladen (Seite 25)

Community S-Series - Operation and Installation Manual - Page 25

Figure 7: S-Series Subwoofer Input Panel

The following figure is an example of the input panel used on S-Series subwoofers.

Subwoofer Input Panel (Typical)

PIN DESIGNATIONS

In the Parallel Output Mode the pin designation is as follows:

• NL4 Pin 1+ and the tip of the ¼” jack connect to the positive (red) output of

the amplifier.

• NL4 Pin 1- and the sleeve of the ¼” jack connect to the negative (black)

output of the amplifier.

Internally, each of these pins are connected to the NL4 output connector, to the ¼” output

jack, and to the drivers in the subwoofer.

In the Hi-Pass Mode the pin designation is as follows:

• NL4 Pin 1+ and the tip of the ¼” jack connect to the positive (red) output of

the amplifier.

• NL4 Pin 1- and the sleeve of the ¼” jack connect to the negative (black)

output of the amplifier.

• Either the NL4 or the ¼" jack on the right side of the input panel may be used

as hi-pass outputs to drive one or more full-range loudspeakers. These hi-pass

outputs exhibit the response that is discussed in the section of this manual

entitled “SELECTABLE HIGH-PASS OUTPUTS ON SUBWOOFERS.” This

Section can be found on Page 16.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Keine Kommentare

Community S-series Installationshandbuch Seite 25